In the wire drawing machine jump (Lut) reel drawing sometimes difficult or pull start why is there no move, even if one could run the fastest speed can not be achieved?
According to wire drawing machine design principles, its drawing power of the former to decrease after the turn, while the pace of work in ascending order, that is, the minimum finished reel of pulling force, speed up. When it comes to jumping (Lut) reel drawing, the drawing force is equivalent to skip a relatively large reel used directly after the one, which increases after a load, it must be fully considered a roll cylinder with a carrying capacity, if the compression ratio selected is inappropriate, may appear difficult or pull start fixed the situation by reducing the compression ratio to solve this problem.
Similarly, when the jump (Lut) is the most high-speed reel for the finished reel machine, or due to overloading, the device will affect the maximum operating speed.
